QoS Queue Setup

In ATM mode, a maximum of 16 queues can be configured.
In PTM mode, a maximum of 8 queues can be configured.
For each Ethernet interface, maximum 4 queues can be configured.
For each Ethernet WAN interface, maximum 8 queues can be configured.
To add a queue, click the  Add  button.
To remove queues, check their remove-checkboxes, then click the  Remove  button.
The Enable  button will scan through every queues in the table. Queues with enable-checkbox checked will be enabled. Queues with enable-checkbox un-checked will be disabled.
The enable-checkbox also shows status of the queue after page reload.

Name	Key	Interface	Qid	Prec/Alg/Wght	DSL Latency	PTM Priority	Shaping Rate(bps)	Min Bit Rate(bps)	Burst Size(bytes)	Enable	Remove
Default Queue	65	1	8/WRR/1	Path0
Default Queue	66	1	8/WRR/1	Path0	Low