NF17ACV - VoIP Generic Setup

Configuring your NF17ACV for VOIP Service

The following steps will take you through the process of setting up your VOIP connection.

  1. Navigate to http://192.168.20.1 in a web browser, using “admin” as both the username and password.

  2. Click Voice from the left hand side menu and then click SIP Basic Setting:

  3. Please select the correct Bound Interface Name from your Internet WAN Service Connection or you can select Any_WAN

  4. Please note for SIP Domain Name: Please leave it blank unless required by your VoIP Provider.

  5. Tick Use SIP Proxy for SIP Account 1, Use SIP Outbound Proxy for SIP Account 1 and Use SIP Registrar for SIP Account 1 and fill them with the SIP Domain name as given by your VoIP Provider.

    If you have 2nd VoIP account then please also tick Use SIP Proxy for SIP Account 2, Use SIP Outbound Proxy for SIP Account 2 and Use SIP Registrar for SIP Account 2 and fill them with the SIP Domain name as given by your VoIP Provider; otherwise don't tick them.

  6. Tick Account Enabled 1 if you only use 1 VoIP account and tick Account Enabled 2 as well if you use 2 VoIP accounts.

  7. Type in your Authentication Name, Cid Name and Cid Number by using your VoIP Phone number and use the same number for Authentication name as well or use the correct VoIP username if it's different from your phone number. Also type in your VoIP password as given to you by your VoIP Service Provider.

  8. Click Apply Button.

  9. Please click SIP Advance Setting and ensure Enable RTCP Flow Control is ticked and click Apply Button.

  10. If all the settings are correct then please click VoIP Status and you should see Registration Status as UP, it means the VoIP is running and ready to be used.

Check for a dial tone on your phone handset. The VoIP account should now be active and you should now be able to make and/or receive VoIP phone calls (depending on the type of VoIP account you are using).