Terminal Lock Problem ATRn

Warning:

Do not set the terminal lock speed command eg. ATR19&W1 to the IG6000. This will cause the modem to go in a loop preventing you from excuting any other AT commands.

  1. The user will need to change Link 1 of the Jumpers back to factory defaults Pin 1 & 2 (Normal mode). 
  2. Once Pin 1 & 2 are set power-up the modem and issue AT&F., this will restore the modem back full factory defaults. 
  3. Power-down the modem and change Link 1 to Pin 2 & 3 to set the modem for save mode.