NAT

Routing

Port Forwarding

Port Forwarding allows you to direct incoming traffic from WAN side (identified by Protocol and External port) to the Internal server with private IP address on the LAN side. The Internal port is required only if the external port needs to be converted to a different port number used by the server on the LAN side. A maximum 32 entries can be configured.

Server Name External Port Start External Port End Protocol Internal Port Start Internal Port End Source IP Address Server IP Address WAN Interface LAN Loopback Enable Delete
Add

Add Port Forwarding Rule

Select the service name, and enter the server IP address and click "Apply/Save" to forward IP packets for this service to the specified server.

NOTE: The "Internal Port End" cannot be modified directly. Normally, it is set to the same value as "External Port End". However, if you modify "Internal Port Start", then "Internal Port End" will be set to the same value as "Internal Port Start".

Remaining number of entries that can be configured: 32

Use Interface:
Service Name:
LAN Loopback:
Source IP address/mask:
Server IP address:
Status:
External Port Start:
External Port End:
Protocol
Internal Port Start:
Internal Port End:
Close

Edit Port Forwarding Rule

Select the service name, and enter the server IP address and click "Apply/Save" to forward IP packets for this service to the specified server.

NOTE: The "Internal Port End" cannot be modified directly. Normally, it is set to the same value as "External Port End". However, if you modify "Internal Port Start", then "Internal Port End" will be set to the same value as "Internal Port Start".

Remaining number of entries that can be configured: 32

Use Interface:
Service Name:
LAN Loopback:
Source IP address:
Server IP address:
Status:
External Port Start:
External Port End:
Protocol
Internal Port Start:
Internal Port End:
Close

Port Triggering

Some applications require that specific ports in the Wi-Fi Hub's firewall be opened for access by the remote parties. Port Triggering dynamically opens the 'Open ports' in the firewall when an application on the LAN initiates a TCP/UDP connection to a remote party using the 'Triggering Ports'. The Wi-Fi Hub allows the remote party from the WAN side to establish new connections to the application on the LAN side using the 'Open Ports'. A maximum of 32 entries can be configured.

Name Trigger Open WAN Interface Delete
Protocol Port Range Protocol Port Range
Start End Start End
Add

Add Port Forwarding Rule

Name:
Use Interface:
Trigger Protocol:
Trigger Port Start:
Trigger Port End:
Open Protocol:
Open Port Start:
Open Port End:
Close

DMZ Host

The Broadband Router will forward IP packets from the WAN that do not belong to any of the applications configured in the Virtual Servers table to the DMZ host computer.

Enter the computer's IP address and click 'Apply' to activate the DMZ host.

Clear the IP address field and click 'Apply' to deactivate the DMZ host.

DMZ Host IP Address:

ALG

Select the ALG below.